Cub Cadet CC 2025 Manual do Operador

Safety • Assembly • Operation • Tips & Techniques • Maintenance • Troubleshooting • Parts Lists • WarrantyWarning: This unit is equipped with an i

10ABCDEFGHILMNOPQRSLow Fuel Indicator LampIndicator Panel/Hour MeterKey Switch ModuleParking Brake LeverPTO SwitchBrake PedalReverse PedalForward Peda

11NOTE: References to LEFT andRIGHT indicate that side of the tractorwhen facing forward while seated inthe drivers seat. Reference to FRONTindicates

12NOTE: A record of the actual hours ofoperation should be kept to assuremaintenance procedures are com-pleted according to the schedule inthis manual

13D. Parking Brake LeverFigure 4 The parking brake lever is located tothe right of the steering wheel in thedash panel. With the brake pedaldepressed

14M. Fuel Fill CapThe fuel fill cap is located on thefender to the left of the seat.N. Cup HolderThe cup holder is located on thefender to the left of

15IMPORTANT: When using powertake-off operated equipment, bestperformance is achieved with thethrottle lever in the “FAST” position.V. Choke LeverThe

16continuously for more than 10seconds at a time. If the enginedoes not start within this time, turnthe key to “STOP” and wait a minuteto allow the en

17Driving On SlopesRefer to the SLOPE GAUGE on page8 to help determine slopes where youmay not operate safely.WARNING: Do not mowon inclines with a s

18Using the REVERSE CAUTION MODE key positionThe REVERSE CAUTION MODEposition of the key switch module allowsthe machine to be operated in reversewith

19Engaging Differential LockFully depress the diff. lock pedal tolock the transmission differential andprovide constant power to both rearwheels when

2Customer SupportIf you have difficulty assembling this product or have any questions regarding the controls, operation, or maintenance of this machin

20SECTION 6: ADJUSTMENTS and MAINTENANCESeat AdjustmentWARNING: Do not adjustthe seat when the tractor ismoving, as this could causethe operator to

21If greater access is required, thetractor is equipped with quick releaseside panels. Remove the quick releaseside panels as follows (See Figure 16):

22Tire InflationKeep the tires inflated to therecommended pressure. Improperinflation will affect tire life and operatorcomfort, and also could affect

23Maintenance Chart† More often under dusty conditions†† Clean every 25 hours or more often under dusty or dirty conditionsNOTE: With the exception of

24Lubrication IllustrationFigure 16 Cub Cadet 251H EP Greaseor equivalent No. 2 lithium greaseEngine Oil: See Figure 27 on page 34Transmission Oil -

25SECTION 7: SERVICEGeneral Battery InformationWARNING• Battery posts, terminals and relatedaccessories contain lead and leadcompounds. Wash hands aft

26Headlight Bulb ReplacementReplace headlight bulbs as follows:(See Figure 17)1. After noting which wire connectsto each terminal, unplug the wirehar

27Changing Transmission OilWARNING: The fluid for yourtransmission has been spe-cially formulated to ensurethe safe and proper opera-tion of your trac

28Electrical BoxThe electrical box contains the relayand fuses. Refer to Figure 19 for theelectrical box layout. The electrical boxis located under th

29From just above the right axle carrier,inside the right frame rail, slowly turnthe hex nylon lock nut at the end ofthe brake rod as follows to adjus

3Section 2: Important Safe Operation PracticesWARNING: This symbol points out important safety instructions which, if not followed, could endanger the

30• Pinch in the lock tabs on the oildrain valve, then pull the drain portoutward to begin draining oil. Referto Figure 24. • After the oil has finish

31SECTION 8: ENGINE INFORMATIONKOHLER CO.FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMSLIMITED WARRANTYSMALL OFF-ROAD EQUIPMENT ENGINESThe U.S. Envir

32LIMITATIONSThis Emission Control System Warranty shall not cover any of the following:(a) repair or replacement required because of misuse or neglec

33Cleaning The EngineThis tractor has an air-cooled engine.Air must be able to circulate freelyaround the engine through the fly-wheel screen, through

34Figure 26 Refer to Figure 27 for informationregarding the proper type of oil to addto the crankcase.• Place the tractor on a level surfaceand engag

35• Remove the flexible tubing from thedrain valve. Clean the tubing andstore in a safe place for future use.• Clean the drain valve and push theplast

36WARNING: Operating theengine with loose or dam-aged air cleaner componentswill allow unfiltered air intothe carburetor, causing ex-tensive wear and

37SECTION 9: TROUBLE SHOOTINGPossible Cause Possible RemedyHard To StartNo fuel in fuel tank or carburetor Fill the tank with fuel. Check the fuel lin

38SECTION 10: OPTIONAL EQUIPMENTThe following attachments and accessories are compatible with your Cub Cadet tractor.See your Cub Cadet dealer for inf

39SECTION 11: SPECIFICATIONSEngineManufacturer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . KohlerHorsepower

4Do not put hands or feet near rotating parts or under the cutting deck. Contact with the blade(s) can amputate hands and feet.A missing or damaged di

40SECTION 12: Replacement PartsDescription Part NumberEngine Oil 737-3030A (10W30)737-3049 (5W30)Air Filter OrderKH-24-883-03-S1Air Filter AssemblyE

41CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSThe California Air Resources Board and MTD Consumer Group Inc are

422. Any warranted part that is scheduled only for regular inspection in the written instruc-tions supplied is warranted for the warranty period stat

43IMPORTANT: To obtain warranty cover-age owner must present an original proof of purchase and applicable maintenance re-cords to the servicing dealer

Cub Cadet LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019, Phone: 1-877-282-8684MTD Products Limited, Kitchener, ON N2G 4J1, Phone: 1-800-668-1238In

5Use slow speed. Choose a low enough speed setting so that you will not have to stop or shift while on the slope. Tires may lose traction on slopes ev

6TowingTow only with a machine that has a hitch designed for towing. Do not attach towed equipment except at the hitch point.Follow the manufacturers

7the original equipment manufacturer’s (O.E.M.) blade(s) only, listed in this manual. “Use of parts which do not meet the original equipment specifica

8Slope GuideUse this page as a guide to determine slopes where you may not operate safely. Do not operate your tractor on such slopes.Operate Garden T

9SECTION 3: TRACTOR PREPARATIONConnect the BatteryBattery posts, terminals andrelated accessories containlead and lead compounds.Wash hands after hand