Cub Cadet 221 HP Manual do Operador descarregar pdf (Página 17)

17Section 7 — Service

Replacing Auger Paddles

The snow thrower auger’s rubber paddles are subject to wear

and should be replaced if any signs of excessive wear are present.

CAUTION: Do NOT allow the auger’s rubber

paddles to wear to the point where portions of the

metal auger itself can come in contact with the

pavement. Doing so can result in serious damage to

your snow thrower.

To change the rubber paddles, proceed as follows:

1. Remove the existing rubber paddles by unthreading the hex

washer screws which secure them to the auger. See Figure 7-4.

Hex Washer Screw

Auger Paddle

Figure 7-4

NOTE: The auger paddles should be replaced one-at-a-time

so that the auger still attached can be used as an example for

positioning and re-installing the new auger.

2. Secure the replacement rubber paddles to the auger using

the hardware removed earlier.

Replacing Shave Plate

The shave plate is attached to the bottom of the auger housing

and is subject to wear. It should be checked periodically. There

are two wearing edges and the shave plate can be reversed.

1. Run the snow thrower until the fuel tank is empty.

2. Pull the recoil starter handle until resistance is felt. Then tip

the snow thrower back until it rests on the handles.

3. Remove the four carriage screws and flange lock nuts

which attach it to the snow thrower housing. See Figure

7-5.

Reversible Shave Plate

Side View

Carriage Screw

Flange Lock Nut

Figure 7-5

4. Install the new shave plate, making sure the heads of the

carriage bolts are on the inside of the housing.

5. Adjust the shave plate as instructed in the Maintenance &

Adjustments section.

6. Tighten securely once adjusted.

Engine

Refer to the Engine Operators manual packed separately with

your snow thrower for service information for your engine.

1 2 ... 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

Cub Cadet 221 HP Manual do Operador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve Cub Cadet 221 HP