Cub Cadet 5234D Manual do Operador

CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 [www.cubcadet.com]IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYWarning: This unit

10NOTE: References to LEFT and RIGHT indicatethat side of the tractor when facing forward whileseated in the drivers seat. Reference to FRONTindicat

11H. Hand HoldsHand holds are built into both the left and right hand fender covers. The handles can be used to assist in mounting and dismounting th

12T. Differential Lock PedalFigure 8 Located at the front of the left running board, thedifferential lock pedal engages the transmissiondifferential

13W. Instrument PanelFigure 11 1. Fuel GaugeThe fuel gauge monitors, at 20 second intervals, thefuel level in the fuel tank. The needle pointing to

14SECTION 2: OPERATIONROLLOVER PROTECTIVE STRUCTURE (ROPS)This tractor is equipped with a Rollover ProtectionStructure (ROPS) and seat belts. When us

15• Do not smoke while refueling the tractor.• Do not fill the fuel tank when the engine isrunning or while the engine is hot.• The fuel fill cap is

16COLD WEATHER STARTING (BELOW 14° F)Move the throttle handle to approximately the"FAST" throttle position, then follow the normalengine st

17USING THE FORWARD AND REVERSE PEDALSThe hydrostatic transmission provides constantlyvariable ground speeds within the speed rating ofeach transmiss

18DRIVING ON SLOPESWARNING: Do not operate on inclineswith a slope in excess of 15 degrees (arise of approximately 2-1/2 feet every10 feet). The trac

19USING THE HYDRAULIC LIFT LEVERThe hydraulic lift system provides power for raisingand positioning three point hitch and belly mountedequipment. To

2TABLE OF CONTENTSTO THE OWNER ...

20Hazard LightsAlways use the flashing amber hazard lights alongwith the SMV (Slow Moving Vehicle) emblem whenoperating the tractor on, or near, road

21USING THE HITCH PLATEUse only the hitch plate (Refer to Figure 22), fortowing pull-behind equipment (carts, trailers, etc.)or dragging loads.Raise

22SECTION 3: ADJUSTMENTSADJUSTING THE SEATFor the comfort of the operator, a single leveradjustable seat is provided to set the fore to aftposition o

23• The length of the upper hitch link is normallydetermined by the design of each implement.To adjust the upper hitch link, loosen the lock-ing leve

24ADJUSTING THE BRAKESThe tractor brakes are adjusted at the factory andshould experience minimal wear if the tractor isoperated normally. However, a

25SECTION 4: MAINTENANCEThe service life and reliability of any machinedepends upon the care it is given. Proper lubrica-tion and maintenance is a vi

26LUBRICATION AND MAINTENANCE CHART (ILLUSTRATION)12667891010121314151617171718413551135192021

27LUBRICATION AND MAINTENANCE CHART† More often when operating under dusty conditions†† If operated less than 100 hours annualyRef.No.Operation tobe

28ACCESSING THE ENGINE COMPARTMENTWARNING: If the tractor has beenrecently operated, engine surfaces(including the radiator) will be HOT.Allow the en

29BATTERY REMOVALWARNING: Battery posts, terminalsand related accessories contain leadand lead compounds. Wash handsafter handling.The battery is loc

3www.cubcadet.comCUB CADET LLCP. O. BOX 361131CLEVELAND, OH 44136DEALER LOCATOR PHONE NUMBER: 877-282-8684Model Number Mfg. DateXXXXXXXXXXX XXXXXXXXX

30HEAD LIGHT BULB REPLACEMENTThe tractor is equipped with headlights. If one of thebulbs should burn out, replace the bulb as follows:• Fully raise t

31Accessing the Fuse CenterThe fuse center is located on the inside right of thedash panel. To access the fuse center, remove thedash panel insert by

32CHECKING TRANSMISSION/HYDRAULIC SYSTEM OIL LEVELCheck the hydro transmission/hydraulic system oillevel before each use. NOTE: Check the oil levelo

33• Remove the old hydrostatic filter by turning itcounterclockwise, and immediately replace withthe new filter. Turn the filter clockwise by handunt

34Dispose of used oil in an environmentallysafe manner. If necessary, contact yourarea EPA office for proper disposal proce-dures and recycling cente

35• To prevent debris from entering the front axlehousing, clean the area around the oil fill plug/dipstick and the axle drain plug located at thecen

36TIRE MAINTENANCECheck the tire air pressure after every 50 hours ofoperation or weekly. Keep the tires inflated to therecommended pressures. Improp

37TRACTOR STORAGEIf your tractor is not going to be operated for anextended period of time (thirty days to approxi-mately six months), the tractor sh

38SECTION 5: ENGINE INFORMATION AND MAINTENANCEDaihatsu L.L.C., the California Air Resources Board (CARB)and the United States Environmental Protecti

39c. Ignition System•Glow plugd. Exhaust System• Exhaust manifolde. Miscellaneous Items Used in Above Systems• Vacuum, temperature, position, time se

4IMPORTANT SAFE OPERATION PRACTICESWARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IFNOT FOLLOWED, COULD ENDANGER THE PERSONAL S

40ENGINE MAINTENANCEWARNING: Use care when servicingany component in the engine area. Ifthe engine has recently been operated,components will be hot

41• Clean the area around the oil filler cap toprevent debris from entering the crankcase.See Figure 50.Figure 50 • Turn the oil filler cap counterc

42• Start the engine and run for about 5 minutes.Stop the engine and check for leaks at the oilfilter and drain plug.• Wait 3 minutes and re-check th

43• Place a suitable container beneath the drainplug and remove the cap from the overflowreservoir.• Turn the drain plug counterclockwise to re-move.

44SERVICING THE FUEL FILTERWARNING: Do not service the fuel filterwhen tractor is hot or near any sourceof ignition. Allow the tractor to cool.The tr

45SECTION 6: SPECIFICATIONSEngineManufacturer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

46SPECIFICATIONS Hydraulic Lift SystemType . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

47SECTION 7: OPTIONAL EQUIPMENT AND ACCESSORIESWhen purchasing your tractor, you probably had it equipped for your particular needs at that time.You

Proper maintenance of your Cub Cadet equipment is the owner’s responsibility. Follow the instructions in your owner’smanual for correct lubricants and

5• Disengage all attachment clutches, thoroughlydepress the brake pedal and shift into neutralbefore attempting to start the engine.• Your mower is d

63. CHILDREN• Tragic accidents can occur if the operator is notalert to the presence of children. Children areoften attracted to the machine. Never

7• Keep all nuts, bolts and screws tight to be surethe equipment is in safe working condition.• Never tamper with safety devices. Check theirproper o

8DIE OUTLINE DOES NOT PRINTWEIGHT MAY NEED TO BE ADDED TO THE TRACTOR. REFER TO TRACTOR OPERATOR’SMANUAL FOR DETAILS.WHEN ADDING FRONT AND / OR REAR

9O.N.M.L.K.SECTION 1: CONTROLS AND FEATURESFigure 1 A.B.C.D.E.F.J.Steering WheelPTO SwitchThrottle HandleIgnition SwitchBrake PedalReverse PedalPTO